|Doorking 9000 Vehicular Slide Gate Operator
|The DKS 9000 series of slide gate operators offer convenience, reliability and safe operation in a small, compact design.
These operators are ideally used in residential, commercial or industrial high-use applications. The steel frame and belt
drive/gear-box reduction system provide a powerful, yet extremely quiet, slide gate operation. The 9000 uses an
advanced microprocessor control circuit with outstanding features. Designed with versatility in mind, these operators will
fit most slide gate operation requirements.
•Steel frame provides strength and quiet operation
•“T-Handle” release is easily accessible from front of operator
•Operator re-connects automatically when handle is released
•Adjustable partial open limit
•Direct driven limit nuts for precise gate control
•Auto-close timer 1-30 seconds
•Ports for plug-in open and reverse loop detectors – DKS detectors only
•Selectable loop/reverse input function; stop or reverse
•Anti-tailgating feature helps to control un-authorized traffic
•Standard normally closed stop circuit
•Gate Tracker reporting output provides operator data to DKS access control system
•Convenience outlets for accessory transformers
•Built-in power switch and alarm reset switch
•Simple bi-parting gate interface
Model 9000 Vehicular Slide Gate Operator
•Maximum gate width 35-ft.
•Maximum gate weight 1000 pounds* (1/2 HP) or 1500 pounds* (1 HP). (*Assumes gate is
on level ground, in good condition with properly adjusted hardware. Other external
factors may affect the performance of the gate operator.)
•1/2 or 1 HP continuous-duty motor
•115, 230*, 208*, 460* VAC. (*230, 208, and 460 volt units use a step-down power
transformer to achieve 115 volt operating voltage.)
•Class I, II, III and IV applications
•Compliant with UL 325 and 991, ETL Listed. (Note: To be compliant with UL 325 and
industry safety guidelines, additional secondary entrapment prevention devices are
required to be installed with this gate operator. Your professional DKS system installer can
provide you with more details on these devices and on current industry safety standards.)
•Dimensions: 16.75"W x 28"H x 19"D
OPTIONS AVAILABLE WITH THIS OPERATOR:
Plug-in loop detectors.
Heater kit for cold environments.
Secondary entrapment prevention devices.
Bi‐parting gate connection cable.
Gate operator control stations
Postal and Fire Dept lock boxes
Surge suppressors, time clocks, trafic signal.
|wired with XLPE insulated wire
and are placed in the roadway
prior to concrete being poured.
|plug-in loop detectors
used for vehicle protection.
|About Us | Contact Us | Our Policies | FAQ | Manufactures | Links |
Copyright Protected 2004-2008 - L. A. Ornamental & Rack Corp. All rights reserved. No part of this site can be reproduced in any form or by
any means, electronic, mechanical, photocopying, or otherwise without prior written consent of L. A. Ornamental & Rack Corp.
3708 NW 82nd Street Miami Florida 33147, Office: 305-696-0419 Fax: 305-696-0461 E-Mail: LAOrnamental@Aol.com
|L. A. Ornamental & Rack Corp
3708 NW 82nd Street
Miami, Florida 33147