 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
Welcome to: GATESNFENCES.COM
| L. A. Ornamental & Rack Corp 3708 NW 82nd Street Miami, Florida 33147 Office: 305-696-0419 Fax: 305-696-0461 |
| About Us | Contact Us | Our Policies | FAQ | Manufactures | Links | Copyright Protected 2004-2008 - L. A. Ornamental & Rack Corp. All rights reserved. No part of this site can be reproduced in any form or by any means, electronic, mechanical, photocopying, or otherwise without prior written consent of L. A. Ornamental & Rack Corp. 3708 NW 82nd Street Miami Florida 33147, Office: 305-696-0419 Fax: 305-696-0461 E-Mail: LAOrnamental@Aol.com |
A complete line of controllers, radio receivers, transmitters, and
accessories for configuring and upgrading access control systems.
Capabilities include telephone entry systems, radio-based products
for remote "keyless entry", "panic" alarms and greater handicapped
access, as well as traditional forms of access control, such as
keypads and swipe card readers.
accessories for configuring and upgrading access control systems.
Capabilities include telephone entry systems, radio-based products
for remote "keyless entry", "panic" alarms and greater handicapped
access, as well as traditional forms of access control, such as
keypads and swipe card readers.
| Linear AP-5 Access Controller The AP-5 is designed for a broad range of access control applications. Its wireless design and small size make it easily adaptable for a variety of access control requirements. Typically, the AP-5 is used to control one or two door strikes, barrier gates, automatic gates, or door operators. The AP-5 contains a high-gain superheterodyne UHF receiver which uses an external antenna to pick up signals from up to 500 feet away. Up to 480 Linear MegaCode transmitters or 238 MDKP keypad entry codes, and six Model MGT gate safety edge transmitters can be programmed into the AP-5’s memory Manual Spec Sheet |
| Linear AP-5 Access Controller Multipurpose wireless access controller ideal for vehicular gate, pedestrian gate, or entry door access 3 relay outputs offer flexibility to control a combination of entry points or obstacle inputs Access relay activation time programmable up to 120 seconds. Access relays are programmable for timed or latch operation. Easy to set-up and use — supports 480 block coded transmitters or 238 individual transmitters/wireless keypad entry codes. Supports six fully supervised gate safety edge transmitters. The AP-5 is a stand alone wireless access controller capable of receiving MegaCode signals from Linear's block coded transmitters up to 500 feet away. It has three separate relays: access, obstacle, and one configurable to either access or obstacle. This system architecture makes it easy to setup, program and configure for applications requiring access control, vehicular gates, pedestrian gates, door strike or mag-locks of commercial office building doors, or any combination. Its wireless design and smaller size makes it suitable for mounting near all access devices. The Access relays of AP-5 are programmable for activation time from 1 to 120 seconds or for latch mode. For automatic swing and slide gates, up to six gate edge transmitters (Linear’s model MGT) can be assigned to obstacle relays to detect entrapment and to trigger an obstacle input on the operator. The MGT is fully supervised gate safety edge transmitter and automatically sends an hourly status report to the AP-5, indicating battery condition and if the transmitter is operational. Should the edge sensor be disconnected, shorted, or tampered with, the MGT will report a trouble condition. The AP-5 is compatible with Linear’s block coded MegaCode format transmitters, which come factory programmed with one of over 1,000,000 possible codes, all but eliminating any chance of duplication. It accepts either 480 block coded transmitters or 238 individual transmitters or wireless keypad entry codes. For the latter, the AP-5 can be used with Linear’s wireless MDKP and MDTK keypads, which accept user codes of two to six digits and transmit them to the AP-5 controller where access is granted or denied. Installation and set-up is simple. The AP-5 operates on 12-24 volts, AC or DC. It can be powered directly from the radio power output of most gate operators. Learning or suspending transmitters is as simple as pressing a few keys on the AP-5’s built-in keypad. Program data is stored in non-volatile EEPROM; data retention is in excess of ten years, even in the event of a power failure. In the access control system, the AP-5 represents tremendous value with many operational and safety features. Features Ideal for gated communities, parking facilities, and industrial sites Easy to set-up and use, up to 480 remotes can be programmed with a few keystrokes Easy to add, suspend, and delete transmitters through programming mode, no transmitter dip switches to set Supports 480 block coded transmitters or 238 individual transmitters/wireless keypad entry codes Supports six fully supervised MGT safety edge transmitters Three output relays; one for access, one for obstacle, one programmable for access or obstacle High-gain superheterodyne receiver RF frequency: 318 MHz 4.45" W x 5.75" H x 1.5" D (without antenna) Product Number: ACP00953 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
