Welcome to: GATESNFENCES.COM
L. A. Ornamental & Rack Corp
3708 NW 82nd Street
Miami, Florida 33147
Office: 305-696-0419
Fax: 305-696-0461
About Us  |   Contact Us   |   Our Policies   |   FAQ   |   Manufactures   |   Links   |   
Copyright Protected 2004-2008 - L. A. Ornamental & Rack Corp.  All rights reserved. No part of this site can be reproduced
in any form or by any means, electronic, mechanical, photocopying, or otherwise without prior written consent of L. A.
Ornamental & Rack Corp.
3708 NW 82nd Street  Miami  Florida  33147, Office: 305-696-0419  Fax: 305-696-0461 E-Mail: LAOrnamental@Aol.com
Custom Decorative Ornamental Wrought Iron and Aluminum Driveway Gates
Gate Openers-Gate Operators, Top Brands,Power Master,Eagle,Elite,RamSet,DoorKing,OSCO,SEA
Custom Decorative Ornamental Estate Metal Driveway Gates
Privacy Gates,Privacy Driveway Gates,Metal Backing,Wood Insert,Privay Panels
Garden Gates, Walk Thru Gates, Garden Walk Through Gates, Wrought Iron or Aluminum Iron Garden Walk Gates
Aluminum Picket Fence, Pool Fence, Security Pool Fence
Custom Fence Wrought Iron Fence Fencing Metal Design Steel Ornamental
Deck Railings, Iron Railings,Porch Railings,Balcony Railings,Hand Rails, Aluminum or Wrought Iron Metal Railings
Control Boards, Main Circuit Boards, MotherBoards, Main Control Circuit Boards for Gate Operators
Remote Controls Multi-Code Linear Liftmaster Chamberlain Clicker Mini Transmitter Heddolf Skylink
Phone entry system, Doorking, American access System, Linear, Elite, Select Engineered,Sentex
Gate Accessories - Roller Guides, Wheels, Hinges, Latches
Gate Openers or Operators Parts - Replacement Parts
Receivers from Linear, DoorKing, Multi-Code, Liftaster, Heddolf, Extended Range
Loop Detectors, PhotoCell, Exit Devices, Emergency Entry Equipment
Multi-code
Liftmaster
Doorking
Linear
Delta 3
Heddolf
Mega-Code
GTO
The MegaCode series of digital receivers are wireless radio controls designed for use with automatic gate openers
or garage door operators. The MegaCode radio format provides unparalleled security. The transmitter and receiver
can be programmed to more than a million different codes. MegaCode receivers and transmitters do not contain a
typical “coding switch”. Each transmitter is pre-set at the factory to a unique code. The receiver is programmed by
sending a signal to it from the transmitter(s) that are going to be used with it. This stores the transmitters code into
the receiver’s memory. The receiver will retain its memory even without power. The receiver will activate only from
these “memorized” transmitters. Each MegaCode receiver can remember a maximum of 40 transmitters. The
receivers can operate from 12-30 volts AC or 10.5-30 volts DC and are normally powered from the gate operator. The
relay contact(s) are rated at 5 amps @ 32 volts AC/DC NEC Class 2 circuit.
Keypads & Telephone Entry Systems
Gate Operator Circuit Boards
Remote Controls
Loop Detectors & Safety Equipment
Recievers
Mega-Code MDRG Receiver
Mega-Code MDRG Receiver
MegaCode series of digital receivers are wireless radio controls
designed for use with automatic gate openers. The MegaCode
radio format provides unparalleled security. The transmitter and
receiver can be programmed to more than a million different
codes
The Linear MegaCode MGR-2 is a 2-Channel Gate Receiver
designed for use with automatic gate operators or systems
where a remote antenna is needed. The MGR-2 can operate two
gates, one gate and an obstacle sensor, or channel one can
open the gate and channel two can close the gate. The receiver
uses the MegaCode radio format with over a million possible
code combinations. Up to 40 transmitters can be programmed
into the receiver.
24-volt, single-channel, three-terminal receiver, 10 code
capacity, MegaCode format.
Features:  •Activates one device   •Wire lead antenna
•Mounting bracket supplied           •Power: 24 VAC/VDC
•Codes: 1,000,000+ (MegaCode format)
•RF frequency: 318 MHz
•Dimensions: 5.5" W x 4" H x 1.25" D
Mega-Code MGR Receiver
Mega-Code MGR Receiver
Linear Mega Code MGR is a 1-Channel Gate Receiver designed
for use with automatic gate operators or systems where a
remote antenna is needed. The receiver uses the MegaCode
radio format with over a million possible code combinations