
| L. A. Ornamental & Rack Corp 3708 NW 82nd Street Miami, Florida 33147 Office: 305-696-0419 Fax: 305-696-0461 |

|
|
| About Us | Contact Us | Our Policies | FAQ | Manufactures | Links | Copyright Protected 2004-2008 - L. A. Ornamental & Rack Corp. All rights reserved. No part of this site can be reproduced in any form or by any means, electronic, mechanical, photocopying, or otherwise without prior written consent of L. A. Ornamental & Rack Corp. 3708 NW 82nd Street Miami Florida 33147, Office: 305-696-0419 Fax: 305-696-0461 E-Mail: LAOrnamental@Aol.com |
| Loop Detectors and Secondary Entrapment Prevention Devices •All DoorKing gate operators are designed with "ports" for our plug-in loop detectors. This simplifies installation and wiring. Both single channel and two channel detectors are available. Loops and loop detectors should be used on all gate operator installations to prevent the gate from closing on vehicular traffic. •DoorKing has available pre-fabricated loops, loop wire, loop test meters and concrete and asphalt sealant. •Two types of photo-beams are available; thru beams and photo-reflective beams. Thru beams have a range in excess of 100 feet but require both a "sender" and "receiver." Photo-reflective beams have a limited range (35-feet), but use a reflector instead of a receiver and are easier to install. •Reverseing edges are good devices to use on slide gates to protect entrapment areas around the gate pocket and gate operator. •Photo-beams are refered to as "non-contact" or type B1 devices, while reversing edges are refered to as "contact" or type B2 devices. Industry safety standards require that a secondary entrapment prevention device be installed with all gate operators. Your professional DoorKing dealer will advise you of the type and number of devices necessary to protect your gate system and to make it as safe as possible for all concerned. |
| Diablo Loop Detectors |
| EDI Loop Detectors |
| Reno Loop Detectors |
| EMX Loop Detectors |
| Preform Loops |